Bending press machine factory in China? World has been committed to the development and production of power press machines since it was established in 1953. More than 100 experienced engineers are working in the three R&D centers, one in Shanghai, one in factory and another one in Ningbo. Discover extra info at https://www.pressmachine-world.com/power-press-machine. We can provide installation service for all the sold out machines at customer factory. Small machines can be shipped assembled and some big machines must be shipped disassembled. That is why we provide installation service to our customer.
The repeatability of the slider of the CNC bending machine is 0.0004 inches, and the precise angle of forming must use suchprecision and a good mold. Therepeatilty of the lder o the hand-controlled bending machine is +0.002 inches, and the deviationo t2-3 is geneally generated under the condition of using a sutable mold. In addition, the Cc bending machine is ready for rapid mold assembly. When many small batches of parts need to be bent, this is an indisputable reason for consideration.
Hydraulic transmission is adopted, and the slider part is composed o slide, an oil cylinder and a fine-tuning structure of a mechaicl stoper. Te left and right oil cylinders are fixed on the frame, the piston (rod) drives the slider to move up and down through hydraulic pressure, and the mechanical stop is controlled by the numerical control system to adjust the value; Workbench part: controlled by the button box, the motor drives the stopper to move back and forth, and the moving distance is controlled by the numerical control system. The minimun reading is 0.01 mm (the front and rear positions have travel switch limits).
When free bending is used, the bending radius is 0.156 times the opening distance of the die. During the free bending process, the opening distance of te die shoul b 8 tms te thickness of the metal material. For example, when using 1/2 inch (0.0127 m) open distance to form 16 gage mild see, the bendig adis o the par is about0.078 inches. I h bndig radius is almost as small as the material thickness, a bottomed die must be formed. However, the pressure required for forming a bottomed die is about 4 times greater than that of free bendingIf the bendig radius is less than the thickness of the material, a punch wit afrontend filet radus smaller than the thickess of the material must be used, and the imprint bending methoc must be used. In this way, 10 times the pressure of free bending is required.
The reason for this is the significantly lower modulus of elasticity of aluminum compared to stel. However, i ore to realise reaterdegrees o defration, sale straightenig rolls must be used. With high-strength steels, on the other hand, a conflict of objectives arises. On the one hand, their high yield strengths require enormous forming forces and torques; on the other hand, small straightening rll diameters are als ned here to ahie asufficent egeo p lstificaton.The straightening o both aluminum and high-strength steels therefore requires a forming geometry adapted to the respective product. This is essentially determined by the number, diameter and spacing of the straightening rolls. Discover extra details at https://www.pressmachine-world.com/.
