LED lighting and aluminum profiles companies by Reboline? You certainly hear and read a lot about the benefits associated with the energy efficiency of LED light emitting diodes versus traditional lighting. When you compare them to other energy-saving illumination methods that are currently available, you will find that LED lamps are definitely the smartest and most power-saving solution for illumination. The top 8 benefits of using LED lights over their less efficient alternatives can be read below. LEDs are packed powerfully with sufficient energy and use up to 90% less power than incandescent light bulbs. Since LEDs use cheaper energy than an incandescent bulb, there is a dramatic decrease in power costs, and thus, the money you dish out every month towards your utility bills. Money and energy are saved in maintenance and replacement costs due to the long LED life expectancy.
Reboline also offers: production facilities with the ability to design custom-made solutions; technical skills to provide support for individual solutions to tailor lighting components; laboratory facilities, where we have a goniometer to assess the photometric curve and a spectrometer to assess the spectral spectrum. We provide quality: Our warehouses have dozens of kilometers of different aluminum profiles and lighting components ready for shipment. ReboLine belongs to a group of lighting companies with over twenty years of experience. Our goal is to provide the highest quality aluminum profiles for LED lighting solutions and implementations. Find even more info at Distribution of aluminium profiles.
Without filaments or glass enclosures, LEDs are breakage resistant and largely immune to vibrations and other impacts. Traditional lighting is usually contained in a glass or quartz exterior, which can be susceptible to damage. LEDs, on the other hand, tend not to use any glass, instead they are mounted on a circuit board and connected with soldered leads that can be vulnerable to direct impact, but no more so than mobile phones and similar small electronic devices. Most fluorescent and HID lamps do not provide full brightness the moment they’re switched on, with many requiring three minutes or more to reach maximum light output. LEDs come on at 100-percent brightness almost instantly however, and with no re-strike delay. This can be advantageous following a power outage or anytime employees open a building during early morning hours when it is still dark outside.
LEDs generally consume very low amounts of power. The statistics to look for when comparing the energy efficiency of different lighting solutions are called by one of two terms: luminous efficacy or useful lumens. These two items essentially describe the amount of light emitted per unit of power (watts) consumed by the bulb. In our experience most LED lighting retrofit projects result in a 60-75% improvement in the overall energy efficiency of the facility’s lighting. Depending on the existing lights and the particular LEDs installed, the savings could be more than 90%. You can read a few case studies here. Because LEDs are so small they can be used in virtually any application you can think of. They can be combined in bunches for a traditional bulb, used in isolation as a small device light, or strung out in sequence in a linear fashion. Just about everything you can think of can be done with LEDs. Read more details on https://reboline.com/.
